Home Tools & Home Improvement Building Supplies HVAC MENSI 2 Packs Flame Sensor Igniter Sensing Rod Fit Replacement of 62-24164-01 Model for Rheem Furnace and 232258 2-Prong Electrode Assembly, Fire Pit Spark with 31.5" High Temperature Cable Wire

MENSI 2 Packs Flame Sensor Igniter Sensing Rod Fit Replacement of 62-24164-01 Model for Rheem Furnace and 232258 2-Prong Electrode Assembly, Fire Pit Spark with 31.5" High Temperature Cable Wire

Replacement of model 62-24164-01 Flame Sensor Igniter Sensing Rod for Rheem Furnace Include two sets and Replacement for Suburban 232258 2-Prong Electrode Assembly, this is high efficiency spark kit with two sparking for fireplace, fire pit , furnace etc
DIY Ignition Parts with Double Sparker and 33.5inch 480°F Resistance High Temperature Cable
Also can be used for any propane or natural igniter system like grill, fire pit and water heater if you can adjust the height of the sparking area to fit your burner
The electrode pin can be bended if you need adjust the installation size
This kit need to be worked with igniter or control system to ignition.

Product information

Manufacturer

‎MNS

Part Number

‎SMT-DHZ020-002/DHX004-002/GJT001-002

Item Weight

‎3.84 ounces

Package Dimensions

‎3.82 x 3.15 x 1.14 inches

Batteries Included?

‎No

Batteries Required?

‎No

Product Description

This kit of the igniter spark plug with high temperature resistance wire can resist around 480°F temperature during working condition.

This is normally used in furnace and high power btu and burner system with much more harder pin and ceramic part with higher voltage during spark. And aslo can be a flame sensor, The sensor is a short length of thin metallic rod that creates a small current of electricity in order to confirm there is fire burning within the furnace. As the gas valve opens to begin the combustion process, the current is sent out from the sensor in order to detect the presence of heat from a flame.
Replacement of 62-24164-01 Flame Sensor Igniter for Reheems Water Heaters Furnace
Replacement of Suburban 232258 2-Prong Electrode Assembly ( Just electrode part)Totally same
But it also can be diy fire pit , fireplace or grill , heater etc.
This can be universal kit if you can adjust the height of spark pin in right posistion. The two pin will increase the power during spark and higher efficiency igniting.
We also include two piece of small rubber cable piece to gather the wire during using.
And cable length 31.5"

Install Process: 1.Shut off the power to your furnace (or any other appliance). It is very important. 2.Remove the broken Sensor and replace it with our new sensor. 3.Turn the power back on, Check the Results.


Spark Plug dimensions If neccessary, you can make the terminal to be straight by a wrench. Suitable for RV furnaces, water heaters, indoor and outdoor kitchens, cooktops, ranges and ovens etc.	High temperature reistsance cable 482°F The cable with terminal fits the electrode terminal and other side with rough 2.3mm terminals	The kit cen be controlled by an igniter or electric system This kit is not only a spark plug electrode kit and also can work with a flame sensor controller by a voltage. you can use it with pulse and piezo ignitions terminal in round.


	Igniter Kit for Weber Grill	120 V Hot Surface Ignitor	24 V Hot Surface Ignitor	1.5 V Push Button Igniter Kit	Piezo Igniter Kit	AA Battery Igniter with Cable
Power	Manual	120V	24V	1.5V	1.5V